Before you can paint over the patch, you must first repair the drywall. Use sandpaper to smooth out imperfections and then apply two or three coats of primer. Let these dry for 24 hours before painting. Afterward, you can apply two or three coats of paint. If the surface is still too rough, sand it again with 100-grit sandpaper.
The most common drywall repair method is patching. This method is ideal for small drywall damage, such as a doorknob hole. Smaller holes can easily be patched with a spackle, a smoothing tool, and some interior painting. However, larger drywall cracks or holes need to be repaired professionally.
If you have a patch that has a large hole, you can fill it with joint compound. Before applying the compound, thin the material with water so that the tape will adhere properly. You should also smooth the tape with a 6-inch knife. To do this, you should pull the knife from the center to each end. You want to squeeze the compound under the tape and out of the wall, without creating a hump in the wall. After the patch is completed, you can paint the entire wall.
Before you start patching, check if the hole is safe to cut. If you are not sure, you can use a flashlight to check if there are any hot wires under the patch. If you are cutting too deep, it may damage the wall or expose electrical outlets. When working on a hole, you must avoid the risk of damaging any wires, such as a telephone wire.
It’s important to note that large holes in the drywall require a considerable amount of time to repair. You should also be patient and understanding while the drywall repair process is underway. It’s important to remember that mesh patches cannot completely hide a large hole. A good tip for patching larger holes is to make sure that the patch is slightly larger than the hole.
Most drywall repair jobs are priced on an hourly basis. This makes it easier to compare costs, as it can be difficult to estimate costs per square foot. For example, a small hole in the drywall that is less than an inch in diameter will only cost about $75 to $100, while multiple holes in a room will cost you up to $500. On the other hand, if the hole is smaller than 4 inches in diameter, you can buy a drywall patch kit and patch it yourself for less than $10. A drywall patch kit includes everything you need to complete the repair, including furring strips.
For larger holes, you should hire the best St. Petersburg handyman. If you are a handyman, you can do simple drywall repairs like nail pops, cracks, and other minor damage. However, if there is water damage, mold growth, or you need to replace the wall, you should call a contractor. If you hire a handyman, make sure that he is licensed and gives you an estimate in writing.